Accessories

The USB-485-XLR cable is a USB to RS485 levels serial UART converter cable incorporating FTDI’s chip USB to serial UART interface IC device which handles all the USB signalling and protocols.
The cable provides a fast, simple way to connect devices with a RS485 interface to USB and in addition, it is USB powered and USB 2.0 full speed compatible and supports a data transfer rate up to 3 Mbaud.

The USB-485-XLR cable contains a small internal electronic circuit board, including the RS485 transceiver. The other end of the cable is equipped with XLR connector in order to control several Marani products such as audio management systems, power amplifiers, graphic equalizers, effects processors etc.

USB-RS485 converter cable provides a USB to RS485 serial interface with XLR end connector.

Suitable for the following products:

Audio Management Systems	DPA240A, DPA260A, DPA360A, DPA440A DPA240P, DPA260P DPA260MFR
Compressor Limiters	CLP2600
Feedback Eliminators	DFP225
Equalizers	DGP230A, DGP231QR

 

• Entire USB protocol handled by the electronics in the cable.
• EIA/TIA-485 communication interface with low power requirements.
• UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity.
• Data transfer rates from 300 baud to 3M baud
• Low USB bandwidth consumption
• USB 2.0 Full Speed compatible.
• -40°C to +85°C operating temperature range
• Cable length: approx. 1.60m (5.25 feet)
• FCC and CE compliant
• Drivers for: Windows 8 and 8 (64bit), Windows 7 and 7 (64bit), Windows Vista and Vista (64bit), Windows XP and XP (64bit)